After a friend's introduction, I successfully acquired new customers. I have never made this wooden product. When they first came to us, we were still hesitant and dared not touch the areas we were not good at. After a long period of communication, we finally reached a cooperation. In the early stage of product development, it takes a lot of time and effort to study the internal structure and detailed design. After a period of trial and error, we successfully made the sample. The customer was very satisfied and placed an order on the spot. This was their third repurchase and we recognized our technical level. Since they were made for entertainment-oriented mechanical equipment, the size of the inside and outside is relatively strict. When we make it, we must go through accurate calculations. A hole position and a thread of lines must be very cautious, otherwise the parts installed inside cannot be properly installed. Most of this product is completed manually, the process is complicated and cumbersome, and the final spray painting effect is also very delicate. It needs to reflect the natural finish of the wood grain and has a glossiness. So you and my customers are welcome to think about it, I will do it, and give you the best quality choice!
